Description
The characteristic of pressure tank for the split solar system
1 The upright tank can make the water temperature to different level, it can hot the top water instantly. The special structure can reduce the cold and hot water to mix together.
2 The tank inside the building, the hot water loss less energy than the normal one.
3 The tank inside the building,the connection pipe between the pipe and the tank is very short, so that hot water can be used instantly and seldom cold water flows out.
4 The heater collector and the water tank is separated, that makes the system combined with building perfectly, which will not reduce the sightseeing for the building and the environment around.
5 Back up with electric heater so that in the day without sunshine hot water can also be used.
The details of this water tank
The inner tank material: SUS316L stainless steel.
The inner tank thickness: 1.2mm.
The out tank: SUS304 stainless.
The out tank thickness: 0.4mm.
The heat insulation material: Polyurethane.
The thickness of the insulation: 55mm.
The use pressure: <6 bar.
The test pressure: 10 bar.
The accessory: a. electrical heater: 1.5KW, 220 V 50Hz.
b. the anode
c. the temperature and pressure relief valve.
d. the sensor.
e. the copper coil heat exchanger: standard equip with one, can select two coil that the tank capacity up to 200L.
f. the drain pipe.
The installation method: vertical.
The tank capacity: 100L, 150L, 200L, 250L, 300L.
Didn't find what you're looking for ?
Post a Buying Lead or contact our
customer service specialist
for help!
or
