supply split solar collector with heat pipe

Characteristic of this type
All-glass evacuated tube adopts vacuum insulation, and the thermal preservation of water tank is foaming of polyurethane at high pressure. Our products are configured with energy saving standard, which solves the heat loss caused by the heat transfer, heat conductivity and heat radiation.
this type of solar water heater works with high pressure, so do the water it produces
The water tank and the solar collector are apart ,it is easy to install.
it uses the heat pipe to delivery the heat energy, it can work more rapidly than others
There is no water in the vacuum tube , so the tube will not break in the winter.
It is steady and credible.
The assemble angle has a great influence on the performance of this type
It will be affected by the local water quality,it does not suit hard water.
It can be combined with the architecture prefectly
It can be combined with existing pipeline.
It can still operate in the event of occasional tube breakages

Technical data:
Number of Tubes 10, 15, 20, 22, 25, 30
Length of Tube 1800 mm
Outer Tube Diameter 58 mm
Inner Tube Diameter 47 mm
Glass Tube Thickness 1.6 mm
Tube Thermal Expansion 3.3 X 10 -6 oC
Tube Material Borosilicate Glass 3.3
Absorptive Coating Graded AI-N/AI
Absorptance > 90% (AM 1.5)
Emittance 7 % (100 oC)
Vacuum P < 0.005 Pa
Stagnation Temperature < 220 oC
Heat Loss < 0.8 W/m2. oC)
Reflector Ginning Alumnium reflector plate
The out cover of the solar connector Alummium aloy manifold.
Frame Alummium aloy frame
Heat pipe type Big heat pipe
Insulation Polyurethane
Tested pressure 1.0MPa
Working pressure 0.6MPa
Daily efficiency >52%